I mean the triangual part at the end, should be more bespoke and smoother way to finnish the shirt placket
top of page
Dear fellow tailor,
Mowgli and I must raise £100,000 by 1 October 2025 to start our "Alterations Video Library" project. We need your support today.
This FREE library will have 200+ videos of individual alterations, indexed by seam. Each video shows a fitting problem, followed by the pattern corrections and final results with side-by-side comparisons.
You will learn to fit in minutes, not days. This will be the most important tailoring project of the century. And you can be part of it by funding it today.
If you ever wanted to change the world, now is your chance. Please join us in making a giant leap in the history of tailoring education.
Thank you,
Reza, Founder of International School of Tailoring
Watch this snippet from Lesson 34. The videos in The Alteration Library will be an enhanced version of this presentation style. This library will make fittings as easy as finding directions with GPS.
So far we have raised £
4870
People have donated
112
Welcome to our forum!
Our forum is an extension of our online coat-making course. Here you can ask questions, discuss ideas and share your work with other students around the world.
Comments (1)
bottom of page
It's a variation of a typical mitred-corner that shirt makers do. The more conventional way follows:
From the wrong side, open up the placket and fold up and inwards its corner by 45 degrees, so that its bottom edge meets the vertical crease of the placket. This has to be done before the typical 1/4 inch edge-stitch along the vertical length of the placket.
Press the fold then pin/baste it in place to ensure that the edge remains secured in the fold. Edge stitch along the diagonal fold. Next, conceal and secure the folded-up edge when doing the 1/4 inch edge stitching along the vertical length of the placket.
Make some samples before doing this on an actual shirt!
The photo you posted shows a slight variation. By the look of things the whole placket is edge-stitched. I leave mine 'open'. To reduce bulk, I cut away the interfacing below the 45 degree fold. I also don't sew the hem all the way into the placket. I cut away some of the 'free' allowance there, which also helps to reduce bulk. The following shots are from an Italian collar shirt, so the placket is slightly different. Same principles apply though (just ignore the bias binding and imagine instead the additional fold of a French placket.